From: Nguyen Xuan Viet (nx_viet@yahoo.com)
Date: Tue Jun 15 2004 - 22:05:59 GMT-3
Hi group,
I had post it before but no reply, so I post twice.
My purpose is to practice E.164 numbering type
I have a VoIP configuration between 2 router
FXS---R1-----------R2-----FXS
(1001) (2001)
like that:
R1#
dial-peer voice 1 pots
destination-pattern +1001
port 1/0/0
!
dial-peer voice 10 voip
destination-pattern .T
session target ipv4: <R2_IP>
R2#
dial-peer voice 1 pots
destination-pattern 2001
port 1/0/0
!
dial-peer voice 10 voip
destination-pattern .T
session target ipv4: <R1_IP>
After that, at R1 I use command csim start 2001, it
works
then, I try to use csim start +2001, it works too. I
have the same result.
But, at R2 when I use csim start 1001 it fails and
error occured:
R2#csim start 1001
csim: called number = 1001, loop count = 1 ping count
= 0csim err csimDisconnected recvd DISC cid(18)
csim: loop = 1, failed = 1
csim: call attempted = 1, setup failed = 1, tone
failed = 0
Then, if I try to use: csim start +1001, it still
doesn't work.
Could you spot out my wrong config, and give me the
suggestion about config it?
Thanks
Viet
__________________________________
Do you Yahoo!?
Yahoo! Mail - Helps protect you from nasty viruses.
http://promotions.yahoo.com/new_mail
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:41 GMT-3