From: jean.paul.baaklini@accenture.com
Date: Tue Jun 08 2004 - 07:39:19 GMT-3
Hi Yasser,
I'm not sitting in my Lab right now.
I configured the BRI 0 as being part of ospf area0.
Sh ip route shows the route as connected.. even though R3's loopback and
BRI are in different networks. (That's strange, I have to admit)
Thanks for your comment.
JP
-----Original Message-----
From: Yasser Abdullah [mailto:]
Sent: 08 June 2004 11:04
To: Baaklini, Jean paul; ccielab@groupstudy.com
Subject: RE: dialer watch and OSPF
Layer 3 to layer 2 mapping should not create a connected route. Can you
paste your config and routing table?
As Richard suggested, it's more like an ospf route type problem.
Yasser
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
jean.paul.baaklini@accenture.com
Sent: Tuesday, June 08, 2004 12:48 PM
To: ccielab@groupstudy.com
Subject: RE: dialer watch and OSPF
Hi Richard,
The problem is the route through the BRI 0 is not seen as OSPF, it's
seen as connected. The administrative distance rules here.
-----Original Message-----
From: Richard Dumoulin [mailto:richard.dumoulin@vanco.es]
Sent: 08 June 2004 10:42
To: Baaklini, Jean paul; ccielab@groupstudy.com
Subject: RE: dialer watch and OSPF
Are both routes Intraarea, Interarea, or one is Intraarea and the other
Interarea ? If they are of the same type, then changing the cost to a
much higher one on the dialer should do the work,
--Richard
-----Original Message-----
From: jean.paul.baaklini@accenture.com
[mailto:jean.paul.baaklini@accenture.com]
Sent: martes, 08 de junio de 2004 11:32
To: ccielab@groupstudy.com
Subject: dialer watch and OSPF
Hi all,
If you conisdere the following layout:
FR FR
R1-----R2-----R3
|____________|
ISDN
We have enabled ospf everywhere on this network, and used a dialer watch
on R1 to "track R3's loopback interface".
The problem is when ISDN comes up, the route to R3's loopback appears
then as connected (there's layer 3 to layer 2 mapping).
Thus, even when the Frame-relay path comes back up, the ISDN line stays
up...
How can I make the route leant through OSPF to be preferred?
Your comments would be much appreciated.
Thanks
Regards,
JP
This message is for the designated recipient only and may contain
privileged, proprietary, or otherwise private information. If you have
received it in error, please notify the sender immediately and delete
the original. Any other use of the email by you is prohibited.
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:35 GMT-3