From: Richard Dumoulin (richard.dumoulin@vanco.es)
Date: Tue Jun 08 2004 - 06:41:41 GMT-3
Are both routes Intraarea, Interarea, or one is Intraarea and the other
Interarea ? If they are of the same type, then changing the cost to a much
higher one on the dialer should do the work,
--Richard
-----Original Message-----
From: jean.paul.baaklini@accenture.com
[mailto:jean.paul.baaklini@accenture.com]
Sent: martes, 08 de junio de 2004 11:32
To: ccielab@groupstudy.com
Subject: dialer watch and OSPF
Hi all,
If you conisdere the following layout:
FR FR
R1-----R2-----R3
|____________|
ISDN
We have enabled ospf everywhere on this network, and used a dialer watch on
R1 to "track R3's loopback interface".
The problem is when ISDN comes up, the route to R3's loopback appears then
as connected (there's layer 3 to layer 2 mapping).
Thus, even when the Frame-relay path comes back up, the ISDN line stays
up...
How can I make the route leant through OSPF to be preferred?
Your comments would be much appreciated.
Thanks
Regards,
JP
This message is for the designated recipient only and may contain
privileged, proprietary, or otherwise private information. If you have
received it in error, please notify the sender immediately and delete the
original. Any other use of the email by you is prohibited.
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:35 GMT-3