From: Yasser Aly (blackyeyes00@hotmail.com)
Date: Sun Jun 06 2004 - 17:09:08 GMT-3
Hello,
If asked to configure router-on-a-stick with dot1q encapsulation. Do I
need to define the native vlan ?
InternetworkExpert says: " Don't forget to add the native keyword on the
appropriate VLAN. Otherwise, the router will not recognoze the traffic since
it is not encapsulated with a vlan header as expected ".
My question: If you were asked to do so but was not provided by which one of
the VLANs is the native one. Should I assume one of them as the native or I
don't assign any native VLANs ??
Regards,
Yasser
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:34 GMT-3