From: Richard Dumoulin (richard.dumoulin@vanco.es)
Date: Sun Jun 06 2004 - 16:35:04 GMT-3
Funny, the doc says "Note <<...>> Only single-digit ranges are supported.
For example, [98-102] is invalid" here
http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/vvfa
x_c/int_c/dpeer_c/dp_confg.htm#wp1067010
<http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/vvf
ax_c/int_c/dpeer_c/dp_confg.htm#wp1067010>
But actually it works depending on the numbers entered !!?!?!? Anyone can
clarify this ? Please see below:
Rack1R5(config)#dial-peer voice 1 voip
Rack1R5(config-dial-peer)#destina
Rack1R5(config-dial-peer)#destination-pattern [98-102]
% invalid [] rangeIncorrect format for ^([98-102])$
Rack1R5(config-dial-peer)#destination-pattern 1[98-102]
% invalid [] rangeIncorrect format for ^(1[98-102])$
Rack1R5(config-dial-peer)#destination-pattern ^(1[98-102])$
% invalid [] rangeIncorrect format for ^(^(1[98-102])$)$
Rack1R5(config-dial-peer)#dest
Rack1R5(config-dial-peer)#destination-pattern 528[8888,9999]
Rack1R5(config-dial-peer)#destination-pattern 528[9999-9999]
Rack1R5(config-dial-peer)#destination-pattern 528[98-102]
% invalid [] rangeIncorrect format for ^(528[98-102])$
Rack1R5(config-dial-peer)#destination-pattern 528[9994-9999]
Rack1R5(config-dial-peer)#destination-pattern 528[11-12]
Rack1R5(config-dial-peer)#destination-pattern 528[11-121]
Rack1R5(config-dial-peer)#destination-pattern 528[91-99]
Rack1R5(config-dial-peer)#
Rack1R5(config-dial-peer)#destination-pattern 528[91-102]
Rack1R5(config-dial-peer)#destination-pattern 528[98-102]
% invalid [] rangeIncorrect format for ^(528[98-102])$
Rack1R5(config-dial-peer)#destination-pattern 528[98-103]
% invalid [] rangeIncorrect format for ^(528[98-103])$
Rack1R5(config-dial-peer)#destination-pattern 528[98-99]
Rack1R5(config-dial-peer)#
This archive was generated by hypermail 2.1.4 : Sat Jul 03 2004 - 19:40:33 GMT-3