From: Tony Schaffran (groupstudy@cconlinelabs.com)
Date: Sun May 30 2004 - 10:03:21 GMT-3
You will need an IOS with a PLUS feature set. If that does not work, you
may have a bad NM module or FXS card.
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Nikolai Tsankov
Sent: Saturday, May 29, 2004 2:17 PM
To: Groupstudy Email (E-mail)
Subject: 2600 & FXS question
Has anyone been able to make these models 2600 recognize the FXS ports
listed below with any 12.2 IOS?
----------------------------------------------------------------------------
---------
R1: cisco 2621 (MPC860) processor (revision 0x200) with 60416K/5120K bytes
of memory.
16384K bytes of processor board System flash (Read/Write)
----------------------------------------------------------------------------
---------
R2: cisco 2611 (MPC860) processor (revision 0x202) with 61440K/4096K bytes
of memory.
16384K bytes of processor board System flash (Read/Write)
----------------------------------------------------------------------------
---------
NM-HD-1V (Carrier module)
VIC2-2FXS (FXS ports)
-------------------------
We couldn't get a clear answer from Cisco's Website.
Thanks,
Nikolai Tsankov
niko@4ovek.com
This archive was generated by hypermail 2.1.4 : Wed Jun 02 2004 - 11:12:19 GMT-3