From: Thomas Larus (tlarus@cox.net)
Date: Thu May 27 2004 - 07:46:45 GMT-3
Just a warning. Be careful about the cable you buy, that it will fit with
the blade. Cisco puts the RJ-21s (I hope that is the right number) pretty
close to each on the 48-port blades. It probably had to do so. Some of
these cable sets have molded plastic that is too big, so that you can only
use half of your switchports on each blade. The molded plastic will fit over
one, but will not fit side by side with another section.
Tom Larus, CCIE #10,014
Author of CCIE Warm-Up: Advice and Learning Labs
----- Original Message -----
From: "CCIE# 12388" <nettable_walker@hotmail.com>
To: "Yasser Aly" <blackyeyes00@hotmail.com>; <ccielab@groupstudy.com>
Sent: Wednesday, May 26, 2004 8:53 AM
Subject: octopus cable for WS-X5012A 48 port ethernet switching blade
> I have the blade & need the cables.
>
> Does anyone have a few for sale ?
>
> Thanks,
>
> Richard
> #12388
>
> //
>
> _______________________________________________________________________
> Please help support GroupStudy by purchasing your study materials from:
> http://shop.groupstudy.com
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Jun 02 2004 - 11:12:17 GMT-3