From: Yasser Abdullah (yasser@alharbitelecom.com)
Date: Mon May 24 2004 - 03:39:58 GMT-3
Use the following command:
R3(config-if)#ppp timeout multilink link add ?
<1-65535> Seconds
From the doc CD:
"If the ppp timeout multilink link add command is not configured but the
dialer wait-for-carrier-time command is, MLP will use the time value set
with the dialer wait-for-carrier-time command. If neither command is
configured, MLP uses a default value of 30 seconds."
Brgds,
Yasser
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Yasser Aly
Sent: Sunday, May 23, 2004 11:43 PM
To: ccielab@groupstudy.com
Subject: Initiating 2 BRI channels regardless of load
Dear All,
Task is asking to fragment all traffic between both ISDN B channels. This
fragmentation should occur regardless of the utilization of the first B
channel.
The solution is: ppp multilink links min 2
I noticed that while using this approach it takes like 30 seconds before
launching the 2nd B channel.
adding the keyword " mandatory " at the end of the command to be
" ppp multilink links min 2 mandatory " the 2nd B channel comes right away
after the 1st one kicks in.
My question is why this happen from the begining as it is supposed to work
without adding the keyword " mandatory " ? Is it related to the switch
config ?
Also if you asked to solve this task will you add the keyword mandatory to
the command or not ?
Your comments are highly appreciated.
Yasser
This archive was generated by hypermail 2.1.4 : Wed Jun 02 2004 - 11:12:16 GMT-3