From: Scott Morris (swm@emanon.com)
Date: Sun May 23 2004 - 19:51:38 GMT-3
Opposite direction... IP Phone must do dot1q trnuking with the switch. On
the 3550, you can leave it alone and dynamic ports work fine. On other
switches (including the NM-16ESw module on the 3700) you must explicitly put
it in trunk mode or things won't work.
It's a long week though. :)
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, CISSP,
JNCIP, et al.
IPExpert CCIE Program Manager
IPExpert Sr. Technical Instructor
swm@emanon.com/smorris@ipexpert.net
http://www.ipexpert.net
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Bob
Sinclair
Sent: Sunday, May 23, 2004 3:56 PM
To: Ahmed Mustafa; ccielab@groupstudy.com
Subject: Re: QOS for 3550
Ahmed,
When configuring voice vlan you will need to configure the port as an
access port. Check out the voice vlan section of the 3550 configuration
guide.
Bob Sinclair
CCIE #10427, CISSP, MCSE
www.netmasterclass.net
----- Original Message -----
From: "Ahmed Mustafa" <ahmed.mustafa@sbcglobal.net>
To: <ccielab@groupstudy.com>
Sent: Sunday, May 23, 2004 3:31 PM
Subject: QOS for 3550
> interface FastEthernet0/11
> switchport access vlan 5
> switchport mode dynamic desirable
> switchport voice vlan dot1p
> switchport priority extend trust
> no ip address
> mls qos trust cos
> spanning-tree portfast
>
> After finishing configuration, I noticed the command, "switchport mode
dynamic
> desirable" is still there, and the only way to get rid of it by setting
mode
> to access or trunk. But it is not recommended since the port is also
carrying
> voice traffic.
>
>
> Any suggestions/
>
> _______________________________________________________________________
> Please help support GroupStudy by purchasing your study materials from:
> http://shop.groupstudy.com
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Jun 02 2004 - 11:12:15 GMT-3