Neighbor command

From: Ahmed Mustafa (ahmed.mustafa@sbcglobal.net)
Date: Mon May 17 2004 - 14:40:59 GMT-3

• Next message: Sergio Jimenez Arguedas: "PIM- SM____IP PIM SPT-THRESHOLD!!!"
• Previous message: Ahmed Mustafa: "Re: IE Lab 15 Task 9.1"
• Next in thread: Kenneth Wygand: "RE: Neighbor command"
• Maybe reply: Kenneth Wygand: "RE: Neighbor command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

If R1 and R2 are connected via Frame-Relay.

The task is to use only physical interfaces, and run ospf. Note: Don't use
ip ospf network command.

What be the best approach. Assign the neighbor statement on either R1 or R2
and set the ip ospf priority to 0 either R1 or R2.

Regards,

Ahmed

• Next message: Sergio Jimenez Arguedas: "PIM- SM____IP PIM SPT-THRESHOLD!!!"
• Previous message: Ahmed Mustafa: "Re: IE Lab 15 Task 9.1"
• Next in thread: Kenneth Wygand: "RE: Neighbor command"
• Maybe reply: Kenneth Wygand: "RE: Neighbor command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Wed Jun 02 2004 - 11:12:13 GMT-3