From: Yasser Abdullah (yasser@alharbitelecom.com)
Date: Mon May 10 2004 - 09:32:18 GMT-3
R2(AS1)-------R3(AS2)
R1 sends R2 150.2.2.0/24. In R2, I'm creating the aggregate 150.2.0.0/16.
I'm trying to manually set the as-path of the aggregate route. That is, I
don't want to use the as-set key work, rather a route-map with the as
prepend set feature.
Here is the command:
aggregate-address 150.2.0.0 255.255.0.0 attribute-map prepend
route-map prepend permit 10
set as-path prepend 1
I keep getting the same error.
Thanks,
Yasser
----- Original Message -----
From: "Tony Schaffran" <groupstudy@cconlinelabs.com>
To: "'Yasser Abdullah'" <yasser@alharbitelecom.com>;
<ccielab@groupstudy.com>
Sent: Monday, May 10, 2004 3:23 PM
Subject: RE: BGP Aggregate AS-Path Prepend
What is the exact command you are trying to issue? Could you paste your
config?
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Yasser Abdullah
Sent: Monday, May 10, 2004 5:15 AM
To: ccielab@groupstudy.com
Subject: BGP Aggregate AS-Path Prepend
Is it possible to prepend an AS path to a locally originated aggregate
route? What I'm trying to do is manually retain the as path without using
the as-set keyword.
I keep getting the following error when using a route/attribute map with the
aggregate-address command:
% "prepend" used as BGP attribute route-map, set as-path prepend not
supported
Many Thanks,
Yasser
This archive was generated by hypermail 2.1.4 : Wed Jun 02 2004 - 11:12:08 GMT-3