From: Church, Chuck (cchurch@wamnetgov.com)
Date: Thu May 06 2004 - 09:26:54 GMT-3
From their registration email (2 years ago, but I assume it's still the
Lake building at the campus):
TO CISCO SYSTEMS: (From the Airport)
Getting your rental car is only the beginning of your trip in the
Raleigh Durham Metropolitan Area.
As you depart the rental car agencies you will begin looking for signs
leading you to Interstate 40 (I-40).
* The exit from the airport is very well marked and the roads are in
good condition.
Just make sure you head West from the Airport (towards Durham) to get
on I-40.
* After a short trip down the access road, you'll be ready to get on
I-40 towards Durham and Davis Drive. Take the Davis Drive exit off of
40. (Approximately 3 miles)
* At the top of the ramp is a traffic light. Turn left onto Davis
Drive.
* Travel for approximately 3 miles on Davis Drive and take a right at
the intersection
of Davis and Kit Creek Road.
* After you turn right, you will go up the hill and turn left at the
flagpoles.
You are now in the main driveway of Cisco Systems at Research Triangle
Park.
Chuck Church
Lead Design Engineer
CCIE #8776, MCNE, MCSE
Wam!Net Government Services - Design & Implementation Team
13665 Dulles Technology Dr. Ste 250
Herndon, VA 20171
Office: 703-480-2569
Cell: 703-819-3495
cchurch@wamnetgov.com
PGP key:
http://pgp.mit.edu:11371/pks/lookup?op=index&search=cchurch%40wamnetgov.
com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Howes, Jack (MSE)
Sent: Thursday, May 06, 2004 8:23 AM
To: ccielab@groupstudy.com
Subject: Direction's to RTP?
Hello all,
I sorry to be asking such a dumb question, but I've gone all over
the Cisco
CCIE web site and can't find direction's to the RTP testing facility
(gulp).
I found the address, but when I put it into mapquest, it came up
with
two different selections and it seemed confused, i.e. The MapQuest
software.
I would have looked in the groupstudy archives, but alas can not
remember
my sign in password. I bet you're all thinking, how will he ever
remember to
turn off "no ip split-horizon eigrp" if Eigrp is used on frame a hub
router in
a frame relay setup, if he can't find directions to the site ;-).
Thanks all for you patience and hopefully a pointer to RTP
/jack
This archive was generated by hypermail 2.1.4 : Wed Jun 02 2004 - 11:12:05 GMT-3