From: Jefferson Orsi Siratuti (jsiratuti@telsinc.com.br)
Date: Tue May 04 2004 - 15:24:32 GMT-3
Scott,
I believe that you is confusing the "neighbor priority" command with
"neighbor cost" command.
Jefferson
-----Original Message-----
From: Scott, Tyson C [mailto:tyson.scott@hp.com]
Sent: quinta-feira, 29 de abril de 2004 16:00
To: Jefferson Orsi Siratuti; ccielab@groupstudy.com
Subject: RE: About OSPF neighbor priority command
When you have different bandwidth over the media between the two end
nodes and you want to prefer the path to the neighbor with the greater
bandwidth is the most common reason to use this command.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Jefferson Orsi Siratuti
Sent: Tuesday, April 27, 2004 4:20 PM
To: ccielab@groupstudy.com
Subject: About OSPF neighbor priority command
Hi,
I4m studying for CCIE LAB and in my tests using OSPF and under the OSPF
router
configuration I can use the command "neighbor x.x.x.x priority xxx" to
specify
a neighbor on NBMA network. So the problem here is that if the neighbor
that I
specify in this command has the "ip ospf priority" entered with a value
different from the above this priority overrides the priority that I set
under
the neighbor command, so my question is what4s the practical function in
use
the neighbor x.x.x.x priority xxx command?
Tks.
Jefferson
jsiratuti@telsinc.com.br
This archive was generated by hypermail 2.1.4 : Wed Jun 02 2004 - 11:12:04 GMT-3