From: cisco@tsgi.net
Date: Sat Apr 24 2004 - 14:08:43 GMT-3
Hi,
How can I configure mvr on switch?
See error message and sh ver for switch.
All comments will be greatly appreciated.
Regards, Darly
I am trying to configure mvr on switch as follows:switch#conf tEnter
configuration commands, one per line. End with CNTL/Z.switch(config)#mvr
^% Invalid input detected at '^' marker.
switch(config)#
switch#sh verCisco Internetwork Operating System SoftwareIOS (tm) C2900XL
Software (C2900XL-C3H2S-M), Version 12.0(5)WC7, RELEASE SOFTWARE (fc1)Copyright
(c) 1986-2003 by cisco Systems, Inc.Compiled Wed 05-Mar-03 10:26 by
antoninoImage text-base: 0x00003000, data-base: 0x0034DEE8
ROM: Bootstrap program is C2900XL boot loader
switch uptime is 2 days, 3 hours, 19 minutesSystem returned to ROM by
reloadSystem image file is "flash:c2900xl-c3h2s-mz.120-5.WC7.bin"
cisco WS-C2924-XL (PowerPC403GA) processor (revision 0x11) with
8192K/1024K bytes of memory.Processor board ID FAB0403R023, with hardware
revision 0x01Last reset from warm-reset
Processor is running Enterprise Edition SoftwareCluster command switch
capableCluster member switch capable22 FastEthernet/IEEE 802.3
interface(s)
32K bytes of flash-simulated non-volatile configuration memory.Base
ethernet MAC Address: 00:B0:64:B0:AD:00Motherboard assembly number:
73-5004-01Power supply part number: 34-0834-01Motherboard serial number:
FAB04024082Power supply serial number: DAB0344416JModel revision number:
A0Model number: WS-C2924-XL-A-SSystem serial number: FAB0403R023Configuration
register is 0xF
switch#
This archive was generated by hypermail 2.1.4 : Mon May 03 2004 - 19:48:54 GMT-3