From: Yasser Abdullah (yasser@alharbitelecom.com)
Date: Fri Apr 23 2004 - 13:03:07 GMT-3
Kenneth,
Good point, I should have mentioned that. However, the correct command
is dialer idle-timeout 0'
Thanks,
Yasser
-----Original Message-----
From: Kenneth Wygand [mailto:KWygand@customonline.com]
Sent: Friday, April 23, 2004 6:51 PM
To: Yasser Abdullah ; Troy; ccielab@groupstudy.com
Subject: RE: Dialer Map "name" parameter
Yasser,
Keep in mind that if you complete the dialer configuration in this way,
the idle timeout will never be reset on the remote side, causing the
link to be torn down and brought up again at its expiration. If you
want to configure it in this manner, I strongly recommend also issuing a
"no dialer idle-timeout" command on the remote router.
Kenneth E. Wygand
Systems Engineer, Project Services
CISSP #37102, CCNP, CCDP, ACSP, Cisco IPT Design Specialist, MCP, CNA,
Network+, A+
Custom Computer Specialists, Inc.
"The only unattainable goal is the one not attempted."
-Anonymous
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Yasser Abdullah
Sent: Friday, April 23, 2004 11:39 AM
To: 'Troy'; ccielab@groupstudy.com
Subject: RE: Dialer Map "name" parameter
The name keyword is used by ppp authentication. It must match the name
the remote side is sending for authentication.
Restricting a router from initiating a call by removing the dial string
can be problematic. A better option would be to include the dial string
and a dialer-group, but configure no dialer-list.
Brgds,
Yasser
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Troy
Sent: Friday, April 23, 2004 6:20 PM
To: ccielab@groupstudy.com
Subject: Dialer Map "name" parameter
All,
Can anyone explain what exactly the "name" keyword for the dialer map
statement is used for?
I know that you must have it for PPP callback. However I noticed that
including the keyword breaks a scenario that I would not think it would.
For example if you ONLY want one side of a BRI to dial. So you omit the
dialer string on the dialer map for the side that should NOT dial to
accomplish this. When the dialer map has the name keyword, but no dial
string, and an incoming call comes in, the connection is established but
there are encapsulation failures back towards the calling router.
If you do not use the name keyword then the scenario works fine. Anyone
know why this causes problems?
R1
dialer map ip 1.1.1.2 name R2 broadcast XXXXXXX
and
R2
dialer map ip 1.1.1.1 name R1 broadcast
---------------------------------
Do you Yahoo!?
Yahoo! Photos: High-quality 4x6 digital prints for 25"
This archive was generated by hypermail 2.1.4 : Mon May 03 2004 - 19:48:54 GMT-3