From: Yasser Abdullah (yasser@alharbitelecom.com)
Date: Thu Apr 22 2004 - 05:00:55 GMT-3
Lee,
Is this a question in a workbook? What value are you trying to set the
revision number to? I'm could be wrong but I've never seen a command
that would manually change this value (unless you are trying to reset it
to zero).
Brgds,
Yasser
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Lee Donald
Sent: Thursday, April 22, 2004 10:25 AM
To: ccielab@groupstudy.com
Subject: Setting VTP revision number on 3550
Can anyone advise where this command is ? The only way I can set the
revision number is to keep adding vlans on the server at the moment, I
can't find it ,where can I manually set it ?
Thanks.
-----------------------------------------------------
You can find us at www.bacs.co.uk
*****************************************************
This communication is confidential and intended for
the exclusive use of the addressee only. You should
not disclose its contents to any other person.
If you are not the intended recipient please notify
the sender named above immediately.
BACS Limited, registered in England, No 1023742,
Drake House, Three Rivers Court, Holmestead Road,
Rickmansworth, WD3 1FX
*****************************************************
This archive was generated by hypermail 2.1.4 : Mon May 03 2004 - 19:48:52 GMT-3