From: Walker, James - Is (JWALKER2@PARTNERS.ORG)
Date: Mon Apr 19 2004 - 16:22:52 GMT-3
More than likely a hardware and code mismatch issue.
What IOS are you running?
You should run 12.2(11)T10 and the code requires minimum of 96Meg DRAM and 32Meg
flash.
Jim
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Carl
Celliers - CPX RSO Jhb
Sent: Monday, April 19, 2004 6:09 AM
To: ccielab@groupstudy.com
Subject: NM-16ESW connection problems
Hello All
I have a problem which I can not figure out.
In my lab kit I have a 3745 with a NM-16ESW (Cat2) and a Cat 3550
(Cat1). When I connect the Cat1 int f0/13 to the Cat2 int f1/13, with a
cross-over cable, the Cat1 int shows it's not connected and the Cat2
says the line is up but the protocol is down. I have tried different
cables (cross-over and straight) and various other ports on the two
switches, all with the same results. Im trying to setup a trunk between
the two switches. The ports are not faulty as ive successfully connected
pc's and routers.
Has anyone experienced something similar?
Is this an official issue with a patch or work around?
Kind Regards,
Carl C
This archive was generated by hypermail 2.1.4 : Mon May 03 2004 - 19:48:50 GMT-3