From: Yasser Aly (blackyeyes00@hotmail.com)
Date: Fri Apr 16 2004 - 10:27:52 GMT-3
Hi Ciro,
FRTS sequence works as follows:
If you applied "frame-relay class " under the main interface, this will be
applied on all DLCI's on this interface. If you need to apply at the same
time two different FRTS patterns whereas one is applied on all the DLCIs and
the other is applied on another DLCI in specific then you use the " class "
command under the frame-relay interface-dlci command.
To summarize:
class command if applied under frame-relay interface dlci, will takeover the
main frame-relay class command defined on the main interface and applied on
the rest of the dlci's.
HTH,
Yasser
>From: C.Sammarcellino@sirtisistemi.it
>Reply-To: C.Sammarcellino@sirtisistemi.it
>To: ccielab@groupstudy.com
>Subject: Help About FRTS
>Date: Fri, 16 Apr 2004 15:10:56 +0100
>
>What is the difference betwen the two following configuration.
>
>Conf: A
>
>interface Serial0/0.52 point-to-point
> ip address 138.10.25.1 255.255.255.252
> ip router isis
> frame-relay interface-dlci 501
> class FRTS_R5
>
>
>
>
>Conf: B
>
>interface Serial0/0.52 point-to-point
> ip address 138.10.25.1 255.255.255.252
> ip router isis
> frame-relay class FRTS_R5
> frame-relay interface-dlci 501
>
>where map-class is:
>
>map-class frame-relay FRTS_R5
> frame-relay cir 128000
> frame-relay bc 128000
> frame-relay mincir 64000
> frame-relay adaptive-shaping becn
> frame-relay priority-group 1
>priority-list 1 protocol ip high tcp telnet
>
>
>Bye
>Ciro
>
>_______________________________________________________________________
>Please help support GroupStudy by purchasing your study materials from:
>http://shop.groupstudy.com
>
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon May 03 2004 - 19:48:48 GMT-3