From: gladston@br.ibm.com
Date: Tue Apr 13 2004 - 12:29:35 GMT-3
Thanks,
The doc says:
"Essentially, you are specifying the ratio of the bandwidth to be allocated to the traffic class.... The sum of the numbers used to indicate this ratio cannot exceed 100 percent."
"By default, when the bandwidth percent and priority percent commands are used to allocate bandwidth, the sum of the bandwidth percentage allocated to the high priority traffic and the bandwidth percentage allocated to the non-priority traffic cannot exceed 75 percent of the total bandwidth available on the interface."
If I understood, if you configure just bandwidth percent, it is possible to configure up to 100%. If you configure bandwidth percent + priority percent, percent should be less than 75%.
I can not see the logical on this. For example, if configuring:
class VOICE
priority percent 10
class FTP
bandwitdh percent 65
You are reserving 25% for control protocols. It is not allowed to configure more than 65% to FTP traffic
If configuring
class FTP
bandwidth percent 100%
What does happen with the control protocols?
This archive was generated by hypermail 2.1.4 : Mon May 03 2004 - 19:48:46 GMT-3