From: Tomikawa (h-tomikawa@syscomusa.com)
Date: Mon Apr 12 2004 - 17:13:12 GMT-3
Hi, Group.
I have a quesiton regarding policy routing on cat3550.
I tested very simple policy routing on cat3550 like
------------------------------------------
!
route-map policy permit 10
match ip address 101
set ip next-hop 10.254.220.2
!
-------------------------------------------
Then, I tried to enable in vlan interface.
SW(config)#int vlan 201
SW(config-if)#ip policy route-map policy
SW(config-if)#end
SW#
SW#sho run int vlan 201
Building configuration...
Current configuration : 96 bytes
!
interface Vlan201
ip address 10.254.201.2 255.255.255.0
end
As you can see that command is not there!!!
Can someone give me an advise?
Thanks
This archive was generated by hypermail 2.1.4 : Mon May 03 2004 - 19:48:46 GMT-3