From: Bob Sinclair (bsinclair@netmasterclass.net)
Date: Fri Apr 09 2004 - 11:28:37 GMT-3
Tim,
Yes, you will need to use the Bridge X route IP command on any router on
which you want to configure a BVI. If you do a show int IRB command, it
will verify which protocols are being bridged and routed on each interface.
All protocols are bridged (only) by default. You will need to both bridge
and route IP to use the BVI.
HTH,
Bob Sinclair
CCIE #10427, CISSP, MCSE
www.netmasterclass.net
----- Original Message -----
From: "Tim Last" <packtmon@yahoo.com>
To: "Group Study" <ccielab@groupstudy.com>
Sent: Friday, April 09, 2004 9:54 AM
Subject: IRB
> Hi guys,
>
> When configuring IRB such that ip can be bridge or routed, does the
command,
>
> bridge # route ip, have to be configured?
>
> Here's what I'm trying to achieve:
>
> I want ip pkts to be able to enter rtr from int S0, bridged to the bvi,
and then routed out int E0. For this to occur do I need the "bridge 1 route
ip" command? Why or why not?
>
>
> bridge-grp 1 S0 rtr E0
>
> router config:
>
> bridge 1 prot ieee
> bridge irb
>
> int S0
> bridge-group1
>
> int bvi 1
> ip addr x.x.x.x
>
> int E0
> ip addr y.y.y.y
>
> Thanks in advance, Tim
>
> Do you Yahoo!?
> Yahoo! Mail - More reliable, more storage, less spam
>
> _______________________________________________________________________
> Please help support GroupStudy by purchasing your study materials from:
> http://shop.groupstudy.com
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon May 03 2004 - 19:48:44 GMT-3