From: Robert (k_robert@tsp.lviv.ua)
Date: Sun Feb 01 2004 - 08:29:38 GMT-3
Kim,
I havenot read the DQOS but RSVP support for LLQ is quite straightforward:
define parameters for PQ ( rate and burst factor ) , enable RSVP, enable
WFQ - that is all.You cannot create RSVP LLQ without defining the criteria
through the
# ip rsvp pq-profile .If you look through the MQC policy-defining lines you
will find nothing concerning RSVP support for LLQ except well-known
#fair-queue , at least I always did first.
Robert
> Hello group,
>
> I am a bit confuse about the what is described in the doc CD compared to
the
> DQOS book about RSVP support for LLQ. Maybe I totally misunderstand the
whole
> thing.
>
> 1) Doc CD:
>
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fqos
_
> c/fqcprt5/qcfrsllq.htm#1005637
> In the doc CD, it describes two required steps to configuring rsvp support
for
> LLQ. One of them is to configure the interface queueing to WFQ.
>
> However,
>
> 2) DQOS book: page 619 and 620
> In this book, it mentioned that in order to have rsvp support for LLQ, you
> need to ensure LLQ is enabled on the interface via the "service-policy"
> command and not by simply configuring WFQ on the interface as explained in
the
> doc CD.
>
> Is there a difference between this two explainations or I misunderstood??
>
> Thank you
> David
>
> _______________________________________________________________________
> Please help support GroupStudy by purchasing your study materials from:
> http://shop.groupstudy.com
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Apr 01 2004 - 08:15:43 GMT-3