From: Wes Smith (wesmith@rogers.com)
Date: Wed Mar 10 2004 - 16:14:02 GMT-3
Doubtfull that mib would be uselful if some other device is doing the ip
encoding. All the network see's is a stream of udp data.
You could (and should) create policy maps to properly identify this
traffic and put it into an LLQ queue
There's a QOS mib that can look at the policy map and pull back stats.
(but its' a very complex mib... it's not just a simple job of reading a
counter)
Airalgerie123@aol.com wrote:
>Hi Group
>
>We are using our network to carry voice traffic, no dial-peer etc.. we use a different Vendor's system to switch voice calls.
>
>Voice call are made, conected to PBX, which then connected to IP network and terminates at a switch.
>
>Would this mib "CISCO-VOICE-DIAL-CONTROL-MIB" still show meaningfull data.
>
>The whole VOICE is not fully implemented yet and therefore I cannot test it.
>
>Cheers
>
>Sam
>
>_______________________________________________________________________
>Please help support GroupStudy by purchasing your study materials from:
>http://shop.groupstudy.com
>
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Apr 01 2004 - 08:15:17 GMT-3