From: Richard Dumoulin (richard.dumoulin@vanco.es)
Date: Thu Mar 04 2004 - 13:01:28 GMT-3
Kenneth, only configure channel-group on the physical interfaces and
everything else on the channel port this way both physical ports will have
the same config :))
--Richard
-----Mensaje original-----
De: Kenneth Wygand [mailto:KWygand@customonline.com]
Enviado el: jueves, 04 de marzo de 2004 16:41
Para: ccielab@groupstudy.com
Asunto: Layer-2 Port Channel & VLANs
Hey everyone,
If I am putting port F0/1 and F0/2 into a layer-2 ether-channel, where
do I include the switchport configurations? (switchport mode access and
switchport access vlan xxx). I'm assuming only on the physical
interface because Cisco says to let the port-channel create itself when
configuring it for layer 2, but I'm not sure.
I believe it will work configured both ways, but which is the "correct"
way?
Thanks!
Kenneth E. Wygand
Systems Engineer, Project Services
CISSP #37102, CCNP, CCDP, ACSP, Cisco IPT Design Specialist, MCP, CNA,
Network+, A+
Custom Computer Specialists, Inc.
"The only unattainable goal is the one not attempted."
-Anonymous
This archive was generated by hypermail 2.1.4 : Thu Apr 01 2004 - 08:15:14 GMT-3