From: kasturi cisco (kasturi_cisco@hotmail.com)
Date: Fri Feb 27 2004 - 16:17:54 GMT-3
Ahmed,
I think your rp-announce and rp-discovery commands have loopback 0 as the
source interface like "ip send-rp-announce scope 10 loo0" or something on
similiar lines.The loo 0 is the address which is being used as RP address
for others. All routers see the MA announce this loopback address as the
RP address.
As a side note the ip pim sparse/sparse-dense mode cmd must be enabled on
the Loo0 interface also.
Good Luck,
Kasturi.
------------------------------------------------------------------------
Contact brides & grooms FREE! Only on www.shaadi.com. Register now!
This archive was generated by hypermail 2.1.4 : Fri Mar 05 2004 - 07:13:59 GMT-3