From: Scott Morris (swm@emanon.com)
Date: Tue Feb 03 2004 - 19:13:26 GMT-3
Oooooo.. Oooo... Appletalk. I remember this. :)
It will depend on what the rest of your configuration is, but those commands
will go the same place in your config as your IP and any other L3 addressing
schemes.
Don't forget a dialer map though if you're configuring in that fashion!
Appletalk is a different protocol than IP!
Wow... I miss having that on the lab. I mean, where else do you get
martians randomly appearing in your network? :)
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, CISSP,
JNCIS, et al.
IPExpert CCIE Program Manager
IPExpert Sr. Technical Instructor
swm@emanon.com/smorris@ipexpert.net
http://www.ipexpert.net
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Kenneth Wygand
Sent: Tuesday, February 03, 2004 4:36 PM
To: ccielab@groupstudy.com
Subject: Appletalk over PPP Multilink Bundle
Hello everyone!
Quick question - if I create a PPP multilink bundle and I want to enable
Appletalk routing over it, do I configure the following on both physical
interfaces, the virtual interface, or both:
appletalk cable-range 100-100 100.1
appletalk zone ZONENAME
I would think just the virtual interface, but that's the way its configured
and its not working right now.
Thanks in advance!
Kenneth E. Wygand
Systems Engineer, Project Services
CISSP #37102, CCNP, CCDP, ACSP, Cisco IPT Design Specialist, MCP, CNA,
Network+, A+
Custom Computer Specialists, Inc.
"Success is to be measured not so much by the position one has reached in
life as by the obstacles which he has overcome while trying to succeed."
-Booker Taliaferro Washington
This archive was generated by hypermail 2.1.4 : Fri Mar 05 2004 - 07:13:45 GMT-3