monitor session question

From: Danny.Andaluz@triaton-na.com
Date: Fri Jan 30 2004 - 20:54:55 GMT-3

• Next message: Scott Morris: "RE: DLSw question - filtering SAPs??"
• Previous message: iwan: "RE: ISDN question"
• Next in thread: Jonathan Hays: "RE: monitor session question"
• Maybe reply: Jonathan Hays: "RE: monitor session question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hey, Group.
 
I'm trying to setup a span port on my 3550. Here is my config:
 
monitor session 1 source interface Fa0/2
monitor session 1 destination interface Fa0/22

For some reason, the switch port shows up/down (monitoring). At first it said up/up (monitoring) but then went down. Does this have anything to do with the software I'm using to analyze traffic? I think I have the monitor session configured according to the Doc CD.
 
 
CAT1#SH INT F0/22
FastEthernet0/22 is up, line protocol is down (monitoring)
  Hardware is Fast Ethernet, address is 000a.8a14.d777 (bia 000a.8a14.d777)
  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 100Mb/s

• Next message: Scott Morris: "RE: DLSw question - filtering SAPs??"
• Previous message: iwan: "RE: ISDN question"
• Next in thread: Jonathan Hays: "RE: monitor session question"
• Maybe reply: Jonathan Hays: "RE: monitor session question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Feb 02 2004 - 09:07:52 GMT-3