From: Nathasha Aleyevka (naleyevka@yahoo.com)
Date: Fri Jan 16 2004 - 22:29:00 GMT-3
Hi,
I tried configuring ISIS with 2 areas on the same router(R1), with one interface E0 in area 49.0001 and S0/0 in area 48.0001. I have enabled the ISIS process on the router and assigned area and system ID to the router:
Interface Ethernet0
ip address 172.16.12.2 255.255.255.0
ip router isis
!
Interface Serial0
ip address 12.16.23.1 255.255.255.252
ip router isis
!
router ISIS
net 49.0001.0000.0001.00
net 48.0001.0000.0001.00
How does the router know which interface is connected to area 48 vs 49?
Can I configure the E0 interface with clns net 47.0001.0000.0001.00 in order to assign this interface to a 3rd area? To connect a new area to the existing one via E0 would I configure this interface as isis circuit-type level-1-2 and assign the clns net XX.XXXX....XX where XX is the new area? Or just configure the E0 as isis circuit-type level-1-2 and under the router ISIS process configure the new area.
Thank you
Nathasha
were up. Routing tables looked ok.
---------------------------------
Do you Yahoo!?
Yahoo! Hotjobs: Enter the "Signing Bonus" Sweepstakes
This archive was generated by hypermail 2.1.4 : Mon Feb 02 2004 - 09:07:46 GMT-3