From: William Lijewski (wlijewski@cox.net)
Date: Thu Jan 08 2004 - 06:28:05 GMT-3
Using IOS 12.2(1d) on the 2500's, Outbound is the default if you hit enter
after the Load Threshold <1-255>.
Router(config)#int bri 0
Router(config-if)#dialer load-threshold 64
Router(config-if)#end
Router#show run int bri
09:49:29: %SYS-5-CONFIG_I: Configured from console by console0
Building configuration...
Current configuration : 174 bytes
!
interface BRI0
no ip address
shutdown
dialer load-threshold 64 outbound
isdn x25 static-tei 0
cdapi buffers regular 0
cdapi buffers raw 0
cdapi buffers large 0
end
Here are a couple of links about dialer load-threshold, but reading through
them they never state what the default is for sure...(watch the wrap):
http://cisco.com/en/US/products/sw/iosswrel/ps1835/products_command_referenc
e_chapter09186a008008000e.html#1123269
http://cisco.com/en/US/tech/tk713/tk507/technologies_tech_note09186a0080112d
3b.shtml#topic2
Bill Lijewski
CCIE #8642
Network Learning Inc
5 Day R&S CCIE Bootcamp Instructor
bill@eccie.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Pun,
Alec CL
Sent: Thursday, January 08, 2004 12:14 AM
To: ccielab@groupstudy.com
Subject: dialer load-threshold [bcc][faked-from]
Importance: Low
If I just input dialer load-threshold 100, does it apply to inbound,
outbound or either ?
thanks
alec
This archive was generated by hypermail 2.1.4 : Mon Feb 02 2004 - 09:07:38 GMT-3