From: asadovnikov (asadovnikov@comcast.net)
Date: Tue Dec 16 2003 - 23:51:36 GMT-3
It was not sufficient in IOS I use to run for production if the RID was
derived from Loopback address versus to manual configuration. I have not
re-tested it recently and it may have changed.
Best regards,
Alexei
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Marvin Greenlee
Sent: Tuesday, December 16, 2003 1:07 PM
To: asadovnikov
Cc: ccielab@groupstudy.com
Subject: RE: OSPF Error Message
You don't necessarily have to reboot the routers.
Usually a "clear ip ospf process" is sufficient.
Regards,
Marvin Greenlee
--- asadovnikov <asadovnikov@comcast.net> wrote:
> It so appears to me that you do have 2 routers with
> same RID. You need to
> reconfigure your routers such as RID is different.
> RID is not changed on the fly, you shall reboot the
> routers before new RID
> takes effect. As such if you changed interface IP configuration which
> would interfere with the above rules you should reboot the
> routers after the
> change is complete.
>
__________________________________
Do you Yahoo!?
Protect your identity with Yahoo! Mail AddressGuard
http://antispam.yahoo.com/whatsnewfree
This archive was generated by hypermail 2.1.4 : Sat Jan 03 2004 - 08:25:42 GMT-3