From: ccie (ccie@netchild.pub.sa)
Date: Fri Dec 12 2003 - 12:59:03 GMT-3
thanx for your input. I will check this out.
there is one thing I want to add, I have an access-list. when I remove the
access list, the cpu reduce to 45% !!!! I have no keyword on the access list
so it should be done on PFC2 card ?!
Regards,
NetChild,
----- Original Message -----
From: "Chris Larson" <clarson52@comcast.net>
To: "ccie" <ccie@netchild.pub.sa>; <ccielab@groupstudy.com>
Sent: Friday, December 12, 2003 6:29 PM
Subject: Re: Ip Input process on Cat6500
> Look at your firewall too...see what its processor is at..
>
>
> If you think the welchia might be a cause you can verify using this
> document:
>
>
http://www.cisco.com/en/US/partner/products/sw/voicesw/ps556/products_tech_n
ote09186a00801b143a.shtml
>
> watch the wrap
>
>
>
>
> ----- Original Message -----
> From: "ccie" <ccie@netchild.pub.sa>
> To: <ccielab@groupstudy.com>
> Sent: Friday, December 12, 2003 10:16 AM
> Subject: Ip Input process on Cat6500
>
>
> > Hi,
> >
> > I want to know what can caused Ip Input process to raise the cpu on
msfc2
> ?
> > we have cat6500 with msfc2. The cpu on msfc2 around 80% and usually it
is
> > 25% in maximum.
> >
> > Plz post any link that you thought it is useful. Cisco we site has a
very
> > good documents, but mostly about 7500 routers :(
> >
> > thanx,
> > NetChild,
> >
> > _______________________________________________________________________
> > Please help support GroupStudy by purchasing your study materials from:
> > http://shop.groupstudy.com
> >
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Please help support GroupStudy by purchasing your study materials from:
> http://shop.groupstudy.com
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Jan 03 2004 - 08:25:39 GMT-3