From: Cocimano, Francesco (FC183400@exchange.Italy.NCR.com)
Date: Fri Dec 05 2003 - 06:29:28 GMT-3
Hi all,
I tried to configure DLSW between router R2 and R3 through Frame Relay.
I got my target but when I dit it I lost layer 3 connectivity between R2 and
R1. Is it caused by bridge-group command in the R2 ethernet interface? Which
command must I type in R2 and R1 to get the connectivity again?
dlsw bridge 1
dlsw local-peer peer-id 150.50.2.2
dlsw remote-peer 0 frame-relay interface Serial0 104
bridge 1 protocol ieee
int eth 0
bridge-group 1
|R1|---------|R2|--------------|R3|
Ethernet Frame-Relay
Thanks
Best Regards
Francesco
This archive was generated by hypermail 2.1.4 : Sat Jan 03 2004 - 08:25:36 GMT-3