Re: ospf network point-to-multipoint

From: Phil (ciscostudent1@yahoo.com.br)
Date: Fri Nov 28 2003 - 19:29:02 GMT-3

• Next message: Brian Dennis: "RE: ospf network point-to-multipoint"
• Previous message: navaid@rogers.com: "ospf network point-to-multipoint"
• Maybe in reply to: navaid@rogers.com: "ospf network point-to-multipoint"
• Next in thread: Brian Dennis: "RE: ospf network point-to-multipoint"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Make sure your loopbacks are configured with 255.255.255.0 mask and apply the "ip ospf network point-to-point" under the loopback interfaces (the default type is loopback, I believe).

navaid@rogers.com wrote:I have ospf network point-to-multipoint configured between R1,R2 and R3.
R2 is frame relay Hub and R1,R3 spoke.
In my routing table I am seeing host routes (/32) for frame interface of R1,R2 and R3 but NO router for subnet. How do I suppress host and see only one route for subnet which is /24.

Thanks,

Navaid

• Next message: Brian Dennis: "RE: ospf network point-to-multipoint"
• Previous message: navaid@rogers.com: "ospf network point-to-multipoint"
• Maybe in reply to: navaid@rogers.com: "ospf network point-to-multipoint"
• Next in thread: Brian Dennis: "RE: ospf network point-to-multipoint"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Dec 12 2003 - 12:29:19 GMT-3