NATing both source and destination

From: Ram Shummoogum (rshummoo@ca.ibm.com)
Date: Thu Nov 27 2003 - 11:33:07 GMT-3

• Next message: Scott Morris: "RE: service tcp-keepalives in"
• Previous message: Bob Sinclair: "Re: Transparent Bridging over DDR"
• Next in thread: Ken.Farrington@barclayscapital.com: "RE: NATing both source and destination"
• Maybe reply: Ken.Farrington@barclayscapital.com: "RE: NATing both source and destination"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

On a firewall it is possible to nat both the source address and destination
at the same time using alias.

Is it possible to do the same on a single router without the firewall IOS?

Thanks,
RAM

• Next message: Scott Morris: "RE: service tcp-keepalives in"
• Previous message: Bob Sinclair: "Re: Transparent Bridging over DDR"
• Next in thread: Ken.Farrington@barclayscapital.com: "RE: NATing both source and destination"
• Maybe reply: Ken.Farrington@barclayscapital.com: "RE: NATing both source and destination"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Dec 12 2003 - 12:29:18 GMT-3