RE: IOS Feature question

From: Danny.Andaluz@triaton-na.com
Date: Sun Nov 23 2003 - 13:55:04 GMT-3

• Next message: Brian McGahan: "RE: tune ospf cost in a broadcast media"
• Previous message: Scott Morris: "RE: Summarizing Access-lists"
• Maybe in reply to: Danny.Andaluz@triaton-na.com: "IOS Feature question"
• Next in thread: Edward Agostinho: "Re: IOS Feature question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

For example, if I have 4 BRI's, but only one is being used (bri0), is there
a way to leave out bri1-3 when I do a "show run"? I'm not sure if a "|
exclude" can include more than one line.

Danny

-----Original Message-----
From: Jonathan V Hays [mailto:jhays@jtan.com]
Sent: Sunday, November 23, 2003 8:18 AM
To: Andaluz, Danilo, Triaton/NA; ccielab@groupstudy.com
Subject: RE: IOS Feature question

Could you please describe the output you are looking for in greater detail?

I use 'sh ip int brief | exclude unassigned' a lot, which gives me a list of
interfaces with IP addresses on a Cisco device.

1#sh ip int brief
Interface IP-Address OK? Method Status
Protocol
FastEthernet0/0 137.10.125.1 YES manual up
up
FastEthernet1/0 unassigned YES manual administratively
down down
Serial1/0 unassigned YES manual administratively
down down
Serial1/1 unassigned YES manual administratively
down down
Ethernet3/0 unassigned YES manual administratively
down down
Serial3/0 unassigned YES manual administratively
down down
Serial3/1 unassigned YES manual administratively
down down
Loopback0 137.10.1.1 YES manual up
up

R1#sh ip int brief | exclude unassigned
Interface IP-Address OK? Method Status
Protocol
FastEthernet0/0 137.10.125.1 YES manual up
up
Loopback0 137.10.1.1 YES manual up
up
R1#

The keywords 'include', 'exclude', and 'begin' can help a lot in filtering
out unwanted lines in your output.

R1#show run | ?
  begin Begin with the line that matches
  exclude Exclude lines that match
  include Include lines that match

HTH,

Jonathan

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Danny.Andaluz@triaton-na.com
Sent: Saturday, November 22, 2003 9:20 PM
To: ccielab@groupstudy.com
Subject: IOS Feature question

Hey, Group. Is there any way to remove unused interfaces from showing up in
the display of a "show run" or "show config"?
 
Thanks,
Danny

• Next message: Brian McGahan: "RE: tune ospf cost in a broadcast media"
• Previous message: Scott Morris: "RE: Summarizing Access-lists"
• Maybe in reply to: Danny.Andaluz@triaton-na.com: "IOS Feature question"
• Next in thread: Edward Agostinho: "Re: IOS Feature question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Dec 12 2003 - 12:29:16 GMT-3