From: Willy Schoots (w.schoots@chello.nl)
Date: Sun Nov 16 2003 - 12:25:26 GMT-3
The reason it not shows up is because cisco is the default string for
authentication.
So hsrp "always" uses authentication with the default password cisco.
Cheers,
Willy
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
k c
Sent: zondag 16 november 2003 8:59
To: ccielab@groupstudy.com
Subject: HSRP Authentication
Something strange! Problem in "standby 1 authen cisco", not show up
after typing the command? Any idea!
R6#sh run int f0/0
interface FastEthernet0/0
ip address 137.10.74.6 255.255.255.192
duplex full
standby 1 ip 137.10.74.1
standby 1 timers 7 17
standby 1 priority 110
standby 1 preempt
standby 1 name ipexpert_r6
standby 1 mac-address 0000.0c07.aaaa
standby 1 track Serial4/0 20
end
R6#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R6(config)#int f0/0
R6(config-if)#stand 1 authentication cisco
R6#sh run int f0/0
Current configuration : 274 bytes
!
interface FastEthernet0/0
ip address 137.10.74.6 255.255.255.192
duplex full
standby 1 ip 137.10.74.1
standby 1 timers 7 17
standby 1 priority 110
standby 1 preempt
standby 1 name ipexpert_r6
standby 1 mac-address 0000.0c07.aaaa
standby 1 track Serial4/0 20
end
Version: (C7200-JK9O3S-M), Version 12.2(15)T8,
Shining Friends!B&n$_&n3x!B73$k&p:q...
.v:)9aAn 1!$_3sC4
http://ringtone.yahoo.com.hk/
This archive was generated by hypermail 2.1.4 : Fri Dec 12 2003 - 12:29:12 GMT-3