RE: unable to tunnel to a module

From: Donny MATEO (donny.mateo@sg.ca-indosuez.com)
Date: Tue Nov 04 2003 - 01:34:37 GMT-3


Yup. It was working fine, until I suddenly realized that all the HSRP
gateway peering are down and I can no longer reach all VLAN IP interface
that are configured on that L3 module. The funny thing is that routed
traffic still can go through to the servers connected to the vlan defined
in that switch...........

Regards,
Donny

"Church, Chuck" <cchurch@wamnetgov.com>
11/04/2003 12:28 PM

 
        To: "Donny MATEO" <donny.mateo@sg.ca-indosuez.com>, <ccielab@groupstudy.com>
        cc:
        Subject: RE: unable to tunnel to a module

Did the module boot up correctly? An MSFC will do something like this
also if the boot fails. I think there's another command other than
'session' that will get to the module. 'console' or 'switch' or something
like that.

Chuck Church
CCIE #8776, MCNE, MCSE
Wam!Net Government Services
13665 Dulles Technology Dr. Ste 250
Herndon, VA 20171
Office: 703-480-2569
Cell: 703-819-3495
cchurch@wamnetgov.com
PGP key: http://pgp.mit.edu:11371/pks/lookup?op=index&search=cchurch%40wamnetgov.com

-----Original Message-----
From: Donny MATEO [mailto:donny.mateo@sg.ca-indosuez.com]
Sent: Monday, November 03, 2003 11:17 PM
To: ccielab@groupstudy.com
Subject: unable to tunnel to a module

Hi All,

Have any of you experience the following error message when trying to
tunnel to L3 module on Catalyst switch ?
cat4k> (enable) sess 2
Trying IntlgLineCard-2...
session: Unable to tunnel to IntlgLineCard-2 (57)
cat4k> (enable)

Donny

http://shop.groupstudy.com

Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html

This message is for information purposes only and its content
should not be construed as an offer, or solicitation of an offer,
to buy or sell any banking or financial instruments or services
and no representation or warranty is given in respect of its
accuracy, completeness or fairness. The material is subject
to change without notice. You should take your own independent
tax, legal and other professional advice in respect of the content
of this message. This message may contain confidential or
legally privileged material and may not be copied, redistributed
or published (in whole or in part) without our prior written consent.
This email may have been intercepted, partially destroyed,
arrive late, incomplete or contain viruses and no liability is
accepted by any member of the Credit Agricole Indosuez group
as a result. If you are not the intended recipient of this message,
please immediately notify the sender and delete this message
from your computer.



This archive was generated by hypermail 2.1.4 : Fri Dec 12 2003 - 12:29:08 GMT-3