Re: GRE encapsulation on Catalyst

From: David Deng (glend_99@yahoo.com)
Date: Mon Oct 27 2003 - 14:39:26 GMT-3

• Next message: nettable_walker@comcast.net: "enable tftp service on a Nortel ASN router ?"
• Previous message: David Deng: "RE: remove the /32 host route for PPPOA virtual Access int"
• Maybe in reply to: Vijay S Jayaraman: "GRE encapsulation on Catalyst"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi VJ,

Here is my 3750.
DMI(config)#int t0
DMI(config-if)#
1w2d: %LINEPROTO-5-UPDOWN: Line protocol on Interface
Tunnel0, changed state ton
DMI(config-if)#tunnel sour
DMI(config-if)#tunnel source lo ?
  <0-2147483647> Loopback interface number

DMI(config-if)#tunnel source lo 0

Regards,
David
--- Vijay S Jayaraman <vjayaram@in.ibm.com> wrote:
> Hi,
> Is the GRE encapsulation for ip tunnelling supported
> on any of the catalyst
> platforms especialy the Catalyst 3750??
> I cannot seem to find the command "interface tunnel"
> on any of the command
> references of any catalyst switch...
>
>
> Regards,
> Vijay.
>
>

• Next message: nettable_walker@comcast.net: "enable tftp service on a Nortel ASN router ?"
• Previous message: David Deng: "RE: remove the /32 host route for PPPOA virtual Access int"
• Maybe in reply to: Vijay S Jayaraman: "GRE encapsulation on Catalyst"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Nov 24 2003 - 07:53:09 GMT-3