From: Danny.Andaluz@triaton-na.com
Date: Tue Oct 21 2003 - 16:23:33 GMT-3
That was part of the problem, but now it doesn't show me the whole config. Just this small part:
r2 con0 is now available
Press RETURN to get started.
User Access Verification
Username: danny
Password:
r2#sh run
Building configuration...
Current configuration : 13 bytes
!
!
!
!
end
r2#sh priv
Current privilege level is 14
R2
-----Original Message-----
From: Brian Dennis [mailto:bdennis@internetworkexpert.com]
Sent: Tuesday, October 21, 2003 2:46 PM
To: Andaluz, Danilo, Triaton/NA; ccielab@groupstudy.com
Subject: RE: Privilege Level Command
Try changing it to "show running-config". "show running-configuration" is not a valid command.
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security) bdennis@internetworkexpert.com
Toll Free: 877-224-8987
Direct: 775-745-6404 (Outside the US and Canada)
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Danny.Andaluz@triaton-na.com
Sent: Tuesday, October 21, 2003 11:17 AM
To: ccielab@groupstudy.com
Subject: Privilege Level Command
Hey Group,
privilege exec level 14 show running-configuration
username danny privilege 14 password 0 cisco
How does the above privilege command NOT allow this user to issue this command. I would think that using this privilege command makes "show run" a level 14 command. However, it doesn't let me issue the command when I login with username danny. Any ideas?
Thanks,
Danny
This archive was generated by hypermail 2.1.4 : Mon Nov 24 2003 - 07:53:06 GMT-3