From: Kleberg, Jason (JKleberg@glhec.org)
Date: Fri Oct 17 2003 - 12:23:32 GMT-3
p391 of the ciscopress dqos book states that the Be setting in CB policing
statement is actually comprised of Bc+Be,
p399 says the same for CAR. So I would set the Be on both of these to 3000,
not 1000.
If i am wrong , please let me know
jason
-----Original Message-----
From: kasturi cisco [mailto:kasturi_cisco@hotmail.com]
Sent: Friday, October 17, 2003 9:30 AM
To: kwchen@netvigator.com; ccielab@groupstudy.com
Subject: Re: Traffic Policing Setting
I think the config should be
Using CB Policing: I should set: "police 160000 2000 1000 conform-action
Usng CAR, I should set "rate-limit 16000 2000 1000 conform-action ...."
The reason i set Be to 1000 bytes is as its given. Also Max burst is
1000+2000 when it happens.If u set the Be to 3000 then it will become
2000+3000 when traffic passes.
HTH.
Good Luck,
Kasturi.
>From: "Chen Kwong Wai William" >Reply-To: "Chen Kwong Wai William" >To:
>Subject: Traffic Policing Setting >Date: Fri, 17 Oct 2003 07:56:38 +0800
> >Dear group, > > If the question asked to police the traffice at
16000bps, 2000Byte Bc, >1000Byte Be. > > Are the settings correct? It is
because the burst-max is actually Bc+Be. > >Best Regards, >William Chen >
>_______________________________________________________________________
>Please help support GroupStudy by purchasing your study materials from:
>http://shop.groupstudy.com > >Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
------------------------------------------------------------------------
Answer simple questions. Win a free honeymoon. Sail into the sunset!
This archive was generated by hypermail 2.1.4 : Mon Nov 24 2003 - 07:53:04 GMT-3