From: A Paradela (aparadela@earthlink.net)
Date: Wed Sep 24 2003 - 17:29:41 GMT-3
RSVP Support for Frame Relay Configuration Task List
To configure Resource Reservation Protocol (RSVP) support for Frame Relay, perform the tasks described in the following sections. Each task is identified as either optional or required.
Enabling Frame Relay Encapsulation on an Interface (Required)
Configuring a Virtual Circuit (Required)
Enabling Frame Relay Traffic Shaping on an Interface (Required) <<
Enabling Enhanced Local Management Interface (Optional)
Enabling RSVP on an Interface (Required)
Specifying a Traffic Shaping Map Class for an Interface (Required) <<
Defining a Map Class with WFQ and Traffic Shaping Parameters (Required) <<
Specifying the CIR (Required)
Specifying the Minimum CIR (Optional)
Enabling WFQ (Required) <<
Enabling FRF.12 (Required) << Would think this one depends on bandwidth / timing requirements.
I believe it has to do with the fact that RSVP requires WFQ.
Thanks, AP
-----Original Message-----
From: Peng Zheng <zpnist@yahoo.com>
Sent: Sep 24, 2003 10:44 AM
To: ccielab@groupstudy.com
Subject: RSVP on frame relay
I asked this several times, but not got a confirmed
answer yet.
Question: On a frame relay subinterface s 0.1
(multipoint), configure RSVP for real-time traffic so
that bandwidth is 400kbps, single-flow is 20kbps.
My solution:
inter s 0.1 mul
ip rsvp bandwidth 400 20
Do I need to configure frame-relay traffic-shaping on
main interface and configure map-class under
subinterface like in:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fqos_c/fqcprt5/qcfrsvfr.htm
when it's not asked?
__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com
***Get your CCIE and a FREE vacation: Shop.GroupStudy.com***
This archive was generated by hypermail 2.1.4 : Wed Oct 01 2003 - 07:24:35 GMT-3