From: Bola Adegbonmire (BolaAD@Resourcery.com.ng)
Date: Wed Sep 24 2003 - 11:05:23 GMT-3
command is only relevant to Rip V2 according CCO
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800ca760.html#1001118
check link for RIP route summarization
-----Original Message-----
From: Danny.Andaluz@triaton-na.com [mailto:Danny.Andaluz@triaton-na.com]
Sent: Tuesday, September 23, 2003 11:08 PM
To: jim.phillipo@guardent.com; ccielab@groupstudy.com
Subject: RE: IP Summary-address rip
I think it does. RIP V1 is classfull so you'd use this command to send summaries that match the interface mask into the RIP network from a router that is also running OSFP or any other classless protocol and redistributing routes into RIP. I'll lab it up and let you know.
Danny
-----Original Message-----
From: Jim Phillipo [mailto:jim.phillipo@guardent.com]
Sent: Tuesday, September 23, 2003 5:45 PM
To: ccielab@groupstudy.com
Subject: IP Summary-address rip
Correct me if I am wrong but this command has no effect with V1 ?
Jim Phillipo, CCNP, CCDP
Sr. Internetworking Engineer
W: 401.456.1821 F: 401.456.0599 M: 508.982.8923
90 Royal Little Drive, Providence, RI 02904
www.guardent.com
This archive was generated by hypermail 2.1.4 : Wed Oct 01 2003 - 07:24:35 GMT-3