From: Snow, Tim (timothy.snow@eds.com)
Date: Tue Sep 16 2003 - 00:52:25 GMT-3
So the two routers can ping across the wireless network but if you "debug ip
packet" or "debug standby" you don't see any HSRP related messages saying
that the multicast messages are making their way across the wiresless LAN.
What type of wireless bridges are these, I'll see if I can find some
documentation about a setting that could be the cause them not to forward
them.
Can you try configuring them without the group # such as (just as a test of
course)
standby priority 115 preempt
standby ip 10.112.50.1
standby track Se0
Tim
-----Original Message-----
From: Uppal, Raj [mailto:RajUppal@mrgmail.com]
Sent: Monday, September 15, 2003 10:46 PM
To: 'Snow, Tim'
Subject: RE: HSRP Not working
Router at site A
Interface FastEthernet 0/0
ip address 10.112.50.2 255.255.0.0
speed 100
full-duplex
ipx network 9
standby 1 ip 10.112.50.1
standby 1 priority 105
standby 1 preempt
standby 1 track Serial0/0.1 10
standby 1 track Serial0/0.2 10
Rtr at Site B
interface FastEthernet0/0
description connected to Lan B
ip address 10.112.50.3 255.255.0.0
speed 100
full-duplex
ipx network 9
standby preempt
standby 1 ip 10.112.50.1
standby 1 priority 115
standby 1 preempt
standby 1 track Serial0/0.1 10
standby 1 track Serial0/0.2 10
Raj Uppal
Mandalay Resort Group
rajuppal@mrgmail.com
-----Original Message-----
From: Snow, Tim [mailto:timothy.snow@eds.com]
Sent: Monday, September 15, 2003 8:42 PM
To: 'Uppal, Raj'
Cc: 'ccielab@groupstudy.com'
Subject: RE: HSRP Not working
I wonder if for some reason the wireless bridges are filtering multicast
messages which HSRP uses to establish adjacencies.
Could you post snippets of the configurations of both routers? Also, what
type of Wireless bridge is it?
Tim
#12042
-----Original Message-----
From: Uppal, Raj [mailto:RajUppal@mrgmail.com]
Sent: Monday, September 15, 2003 10:29 PM
To: 'ccielab@groupstudy.com'
Subject: HSRP Not working
There are two routers connected to a LAN, the two lans are connected
together via a Wireless LAN Bridge. The two routers can ping each other but
don't see each other when issued a command "show standby" says standby
router is unknown. When using "debug standby" no messages are seen. Both
routers are acting as active. Any thoughts?
Raj Uppal
Mandalay Resort Group
***Get your CCIE and a FREE vacation: Shop.GroupStudy.com***
This archive was generated by hypermail 2.1.4 : Wed Oct 01 2003 - 07:24:28 GMT-3