From: Scott Morris (swm@emanon.com)
Date: Sun Aug 17 2003 - 18:07:25 GMT-3
There are three methods I can think of.
1. As noted, change the ip ospf interface type on the loopback
2. Create an area range for the area in question
3. redistribute connected
HTH,
Scott
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Nathaly Landry
Sent: Sunday, August 17, 2003 12:01 PM
To: Ken.Farrington@barclayscapital.com; ccielab@groupstudy.com
Subject: RE: OSPF and Loopbacks
Loopbacks are adv as stub networks (/32) the way to change this
is to use under the int loop 601 Ip os net type point-to-point
nat
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Ken.Farrington@barclayscapital.com
Sent: Sunday, August 17, 2003 11:57 AM
To: ccielab@groupstudy.com
Subject: OSPF and Loopbacks
Hi Guys,
Hope everyone in the US has power now :)
One very quick one. Why does OSPF advertise loopbacks with a /32 bit
mask, if the loopback is configured as a network ie,
int lo 601
ip address network 192.168.1.1 255.255.255.0
many thx, and I hope someone alse has seen this.
Kind regards,
Ken
------------------------------------------------------------------------
For more information about Barclays Capital, please
visit our web site at http://www.barcap.com.
Internet communications are not secure and therefore the Barclays
Group does not accept legal responsibility for the contents of this
message. Although the Barclays Group operates anti-virus programmes,
it does not accept responsibility for any damage whatsoever that is
caused by viruses being passed. Any views or opinions presented are
solely those of the author and do not necessarily represent those of the
Barclays Group. Replies to this email may be monitored by the Barclays
Group for operational or business reasons.
------------------------------------------------------------------------
This archive was generated by hypermail 2.1.4 : Tue Sep 02 2003 - 18:54:00 GMT-3