From: Peng Zheng (zpnist@yahoo.com)
Date: Wed Aug 13 2003 - 00:27:06 GMT-3
I miss that. But Actually, I already add bridge group
1 to e 0.2.
--- OhioHondo <ohiohondo@columbus.rr.com> wrote:
> Add bridge group 1 to e0.2 and try again.
>
> -----Original Message-----
> From: nobody@groupstudy.com
> [mailto:nobody@groupstudy.com]On Behalf Of
> Peng Zheng
> Sent: Tuesday, August 12, 2003 4:10 PM
> To: ccielab@groupstudy.com
> Subject: IRB and Trunk config, failed
>
>
> E0 of R1, R2 and R3 connect to switch.
>
> I configure R3 as irb.
>
> on R1:
>
> int e 0
> ip add 192.168.1.2 255.255.255.0
>
> on R2
>
> ip add 192.168.1.3 255.255.255.0
>
> I enable trunk on switchport which connect to r3
> with
> dot1q encapsulation. The port to r1 in Vlan 2, the
> port to R2 in Vlan 3.
>
> Then on R3:
>
> bridge irb
>
> int e 0
> no ip add
> int e 0.1
> encap dot1q 2
> bridge-g 1
> int e 0.2
> encap dot1q 3
>
> bridge 1 protocol ieee
>
> --------------------------------
>
> r1 and r2 can ping each other.
>
> Then on r3, I add:
>
> int bvi 1
> ip add 192.168.1.4 255.255.255.0
> bridge 1 route ip
>
>
> But r1 and r2 can not ping 192.168.1.4, why?
>
> Thanks.
>
>
> __________________________________
> Do you Yahoo!?
> Yahoo! SiteBuilder - Free, easy-to-use web site
> design software
> http://sitebuilder.yahoo.com
>
>
>
This archive was generated by hypermail 2.1.4 : Tue Sep 02 2003 - 18:53:58 GMT-3