From: Naga Sayeenathan (naga@nmhcrx.com)
Date: Tue Aug 12 2003 - 01:31:23 GMT-3
Clns router isis command is needed only for multiarea IS-IS. ie.,If u have
Router isis 1 , router isis 2 .
It is optional for conventional (single area) IS-IS.
http://www.cisco.com/en/US/customer/products/sw/iosswrel/ps1835/products_com
mand_summary_chapter09186a00800804f0.html#1040219
Thanks
naga
-----Original Message-----
From: Peng Zheng [mailto:zpnist@yahoo.com]
Sent: Monday, August 11, 2003 12:04 PM
To: ccielab@groupstudy.com
Subject: IS-IS config
In some document:
To configure Integrated IS-IS on a Cisco router, both
the clns router isis and ip router isis commands must
be enabled in interface configuration mode.
But a lot of solution for ISIS only enable ip router
isis under the interface, and it does work. Then,
should I add clns router isis during the lab if asked
for ISIS?
__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com
This archive was generated by hypermail 2.1.4 : Tue Sep 02 2003 - 18:53:57 GMT-3