From: Tomasz Szymanski (tomasz.szymanski@trecom.pl)
Date: Wed Jul 30 2003 - 18:43:17 GMT-3
It must be used when you want to summarize this networks
TS
ccie2be wrote:
>Hi,
>
>What's the reason or benefit of changing the ospf network type for a loopback
>interface from it's default to a point to point?
>
>I realize that if the network type is not changed then OSPF will install a
>host route in the routing table, but so what? Are there any circumstances
>where not changing the network type will cause routing problems?
>
>Thanks, Jim
>
>
>_______________________________________________________________________
>You are subscribed to the GroupStudy.com CCIE R&S Discussion Group.
>
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:52:59 GMT-3