From: Rivalino YMT. (rivel131@cyberlib.itb.ac.id)
Date: Wed Jul 23 2003 - 00:09:23 GMT-3
There is weird config on Documentation.
It is on Catalyst 3550, chapter "Configuring Fallback Bridging"
This what it says:
This example shows how to create bridge group 10 and to specify that the
VLAN-bridge STP runs in the bridge-group. It defines an interface as an
SVI and assign this interface to VLAN 2 and to the bridge group:
Switch(config)# bridge 10 protocol vlan-bridge
Switch(config)# vlan 2
Switch(config-vlan)# exit
Switch(config)# interface vlan2
Switch(config-if)# exit
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan2
Switch(config-if)# no switchport
Switch(config-if)# no shutdown
Switch(config-if)# bridge-group 10
My question:
Can we activate fallback-bridging on switchport? What I understand that we
can ONLY run fallback bridging on SVI and Routed port.
Is it wrong configuration?
(another error: it configures "switchport" then put it down again "no
switchport")
Please anyone confirm this.
Thanks,
Rivalino
This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:52:49 GMT-3