From: Jonathan V Hays (jhays@jtan.com)
Date: Fri Jul 18 2003 - 11:45:58 GMT-3
I disagree. Do frame-relay map every place you can (the only place it
won't work is a point-to-point subinterface).
Brian Dennis said it best in the following post:
From: nobody@groupstudy.com on behalf of Brian Dennis
[brian@labforge.com]
Sent: Sunday, June 22, 2003 12:08 AM
To: 'Wei Zou (wzou)'
Cc: ccielab@groupstudy.com
Subject: RE: Frame Relay question
Is there a reason you are not using a frame-relay map statement on R2?
Do not rely on inverse-arp in the CCIE lab. ALWAYS use frame-relay map
statements on physical interfaces or multipoint subinterfaces if the lab
permits. Properly configured frame-relay map statements work 100% of the
time whereas inverse-arp does not work 100% of the time.
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
> Behalf Of jatinder.p.singh@bt.com
> Sent: Friday, July 18, 2003 6:14 AM
> To: chawalit.k@dcs.premier.co.th; ccielab@groupstudy.com
> Subject: RE: What is recommand config for frame-relay
> point-to-point inte rface in the LAB
>
>
> config frame relay dlci command on point to point and config
> frame-relay map
> on point to multipoint.
>
> Regards
>
> J P singh
>
> -----Original Message-----
> From: Chawalit Kongpatpanit [mailto:chawalit.k@dcs.premier.co.th]
> Sent: 18 July 2003 02:17
> To: ccielab@groupstudy.com
> Subject: What is recommand config for frame-relay point-to-point
> interface in the LAB
>
>
> Hi All,
>
> I would like to know recommand config for frame-relay point-to-point
> interface in the LAB.
> R1 (Physical Interface) -----------F/R
> network--------------R2 (Physical
> Interface)
> I know it have 2 way one is frame-relay map statement and frame-relay
> interface dlci
>
> 1.
> R1# interface s0
> encapsulation frame-relay
> no frame-relay invert-arp
> frame-relay map ip x.x.x.x (dlci) broadcast
> R2# interface s0
> encapsulation frame-relay
> no frame-relay invert-arp
> frame-relay map ip x.x.x.x (dlci) broadcast
> 2.
> R1# interface s0
> encapsulation frame-relay
> frame-relay interface-dlci (dlci)
> R2# interface s0
> encapsulation frame-relay
> frame-relay interface-dlci (dlci)
>
> What is your suggestion. Or you think Can I config both ?
>
> Thank
>
>
> ______________________________________________________________
> _________
> You are subscribed to the GroupStudy.com CCIE R&S Discussion Group.
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
> ______________________________________________________________
> _________
> You are subscribed to the GroupStudy.com CCIE R&S Discussion Group.
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:52:44 GMT-3