From: Frank Jimenez (franjime@cisco.com)
Date: Fri Jul 18 2003 - 00:19:37 GMT-3
Couple of good links:
Understanding How Inbound and Outbound Dial Peers are Matched on Cisco IOS
Platforms
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed
1.shtml
Understanding the Operational Status of Dial Peers on Cisco IOS Platforms
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010e6d
1.shtml
Remember that you have two different cases to consider - inbound dial peers and
outbound dial peers.
With inbound, IOS checks (in order:)
1.) Called number (DNIS) with incoming called-number
2.) Calling Number (ANI) with answer-address
3.) Calling Number (ANI) with destination-pattern
With outbound, IOS checks destination-pattern unless you have DID configured -
then it uses incoming called-number.
Frank Jimenez, CCIE #5738
franjime@cisco.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of csc
david
Sent: Thursday, July 17, 2003 8:49 PM
To: ccielab@groupstudy.com
Subject: voip
Hi,I have a question about voip:
dial-peer voice 1 pots
incoming called-number 4085556400
answer-address 9195552001
destination-pattern 919#9195552!-
what is the difference between the "incoming called-number","answer-add" and
"dest-patt"? I searched some docs in cisco.com, but still cannot understand.
Thanks a lot
---------------------------------
Do You Yahoo!?
9zDZ5gSJSC;'74@,;x5w2i@-?*a!D;
This archive was generated by hypermail 2.1.4 : Wed Aug 06 2003 - 06:52:44 GMT-3